hard tail

Hello all, I know it's near sacrilege to chop up an old XS frame, but I felt this frame was a good candidate because when I bought it it had already had some of the seat pan chopped off, as well as some of the frame around the swing arm though I can't say for sure what those frame bits did...

Up for grabs is a rigid hardtail Yamaha XS 650 project with title and matching free spinning motor. Frame is ready to go and this comes with a second free spinning motor. One has electronic ignition. Rims have been sand blasted already, just need paint. Tires and tubes are new. I have a bin of...

Hard Tail Frame for sale Don't know who made the hard tail. But, it looks like a quality product. Frame is bare. No carbs. No electronics. Has bad rotor. Good compression. I was told by PO that it did run. With motor $150 Without motor $100 Local pick up only NO TITLE **Disregard date stamp...

My custom chopper, 2+ years in the making. Started full stock all-original, barn find. The only thing 100% original left is the clutch lever. :-) 19" total stretch with hard-tail, gooseneck and 45-degree rake custom springer.

FOR SALE: '78 or '79 Yamaha XS650 XS-F custom, hard tail frame. Has forward controls, kickstand, battery box, fender struts, wiring under seat and through frame. NO TITLE. MIG welded in jig, tracks straight, ran for years. Can be run as is or clean it up and show it some love! $500 shipped in...

I'm building a 75' xs I've been fabbing my own hard tail. I'm fixin to buy plates, easier than making them myself. Any suggestions on where or who to get them from? Thanks Brandon

I sent over some basic pictures to Pipeburn and they were all about it. I would like to thank Scott for doing the writeup. http://www.pipeburn.com/home/2012/2/21/1976-yamaha-xs360-bombshell-customs.html Here are a few photos of a recent photoshoot of a bike I recently built. Its a 1976 Xs 360...

Has anyone ever stretched a tc bros hardtail? I think I may give it a whirl, 2 or 3 more inches. Any thoughts