Airwolfie
XS650 Guru
- Mount headlight properly DONE!!!
- Find replacement line for clutch DONE!!!
- finish off foot pegs DONE!!
- mount indicators DONE!!
- mount coils DONE!!!
- mount tacho and speedo DONE!!
- mount Boyer ignition DONE!!!
- add fake oil tank for housing electrics DONE!!
- add key starter DONE!!!
- add hi/lo light switch DONE!!!
- add kill switch DONE!!!
- add neutral light DONE!!!
- add spark leadsDONE!!!
-Install Boyer power boxDONE!!!
-Install one way valve on breather DONE!!!
-Bleed clutchDONE!!!
- plug excess petcock holesDONE!!!
- add petcockDONE!!!
- install fuel lineDONE!!!
- add filter podsDONE!!!
-clean and line gas tankDONE!!!
- fabricate rear fenderDONE!!!
- mount rear fenderDONE!!!
- mount rear lightDONE!!!
- add hornDONE!!!
- replace tyresDONE!!!
- fab steering stopDONE!!!
- make spacers for calipers/rotorsDONE!!!
- paint gas tankDONE!!!
- add chainDONE!!!
- Find replacement brake line for front brakeDONE!!!
- recon front caliperDONE!!!
-Bleed brakesDONE!!!
- sort out exhaustsDONE!!!
- mount rear brake switchDONE!!!
- wire entire bikeDONE THE ENGINE!!!
- add oilDONE!!!
- mount front fenderlDONE!!!
- add fuelDONE!!!
- run engineDONE!!!
- paint fenders
- mount number plateDONE!!!
- tune engine
- get MOT!!
Got my number plate today, so I stuck it on.
I also started on some prep and paint on the front mudguard
- Find replacement line for clutch DONE!!!
- finish off foot pegs DONE!!
- mount indicators DONE!!
- mount coils DONE!!!
- mount tacho and speedo DONE!!
- mount Boyer ignition DONE!!!
- add fake oil tank for housing electrics DONE!!
- add key starter DONE!!!
- add hi/lo light switch DONE!!!
- add kill switch DONE!!!
- add neutral light DONE!!!
- add spark leadsDONE!!!
-Install Boyer power boxDONE!!!
-Install one way valve on breather DONE!!!
-Bleed clutchDONE!!!
- plug excess petcock holesDONE!!!
- add petcockDONE!!!
- install fuel lineDONE!!!
- add filter podsDONE!!!
-clean and line gas tankDONE!!!
- fabricate rear fenderDONE!!!
- mount rear fenderDONE!!!
- mount rear lightDONE!!!
- add hornDONE!!!
- replace tyresDONE!!!
- fab steering stopDONE!!!
- make spacers for calipers/rotorsDONE!!!
- paint gas tankDONE!!!
- add chainDONE!!!
- Find replacement brake line for front brakeDONE!!!
- recon front caliperDONE!!!
-Bleed brakesDONE!!!
- sort out exhaustsDONE!!!
- mount rear brake switchDONE!!!
- wire entire bikeDONE THE ENGINE!!!
- add oilDONE!!!
- mount front fenderlDONE!!!
- add fuelDONE!!!
- run engineDONE!!!
- paint fenders
- mount number plateDONE!!!
- tune engine
- get MOT!!
Got my number plate today, so I stuck it on.
I also started on some prep and paint on the front mudguard