roadstar06
XS650 Addict
here's the problem-bike stalls when put in 1st gear- clutch plates sticking? that's what I thought what else can cause this>??? took right cover off dis-assemble clutch pack 7 fiber-6 steel (2fo) motor-long rod upgrade.discs out big washer,bearing,washer, remove hub can't get large spacer off?? came right out when I pulled motor apart for rebuild? any tricks to get this pc. off?? 2 washers behind are correct as I did alot of reading to find correct sequence. not sure why hub spacer is locked on shaft? ok, so I put it all back together torque nut to 56lbs. according to popular posts. side cover still off, put in 2nd gear can turn rear wheel but very hard (rear wheel off ground and clutch lever pulled in mind you) put in 3rd a bit easier,4th easier still 5th easier still-bump it down to 1st and its a bear! have clutch adjusted properly althought not crazy about how it sits in adjuster space and adj. spring appears to be a bit worn or stretched (I don't know how it should look or feel new) any input would be much appreciated. thanks...Q:#2--I lowered front shock 3in. how much oil do i add? and what do you use to measure fluid I can't find a cc measure tube.
Last edited: