YOURADHERE
XS650 Addict
- Messages
- 181
- Reaction score
- 0
- Points
- 16
I know, search, and I have and have ended up even more confused. I think I have this correct but I'm looking for confirmation as well as have a few questions.
The specs:
72 XS650
Pamco Ignition
Using 4 pole ignition switch
Previous owner had wired it but alot was half-assed so I decided to just start over and went back to electric start(currently kick only). I'll also be adding in a brake light switch(not shown in my current diagram).
First, here's a diagram that I found on the net that I've followed loosely and I have a couple questions when referencing it.
Here's my wiring as it currently sits. I figured I'd stop, draw up this diagram and then proceed once I have my questions solved.
Question 1: The wiring for my stator has a yellow wire that was capped off on it's own, not connected to anything. From my understanding it should stay this way. Correct?
Question 2: The 6 pin connector from my stator has a blue wire that is not connected to it(shown in my diagram) as well as a blue wire coming out of my regulator that also is not connected to anything. Where/what do these connect to?
Question 3: My coil has a blue wire and a black wire coming out of it. I'm assuming the black is negative, blue is positive. Do I have this hooked up correctly?
Any other tips/corrects/revisions? Any help would be greatly appreciated.
The specs:
72 XS650
Pamco Ignition
Using 4 pole ignition switch
Previous owner had wired it but alot was half-assed so I decided to just start over and went back to electric start(currently kick only). I'll also be adding in a brake light switch(not shown in my current diagram).
First, here's a diagram that I found on the net that I've followed loosely and I have a couple questions when referencing it.
Here's my wiring as it currently sits. I figured I'd stop, draw up this diagram and then proceed once I have my questions solved.
Question 1: The wiring for my stator has a yellow wire that was capped off on it's own, not connected to anything. From my understanding it should stay this way. Correct?
Question 2: The 6 pin connector from my stator has a blue wire that is not connected to it(shown in my diagram) as well as a blue wire coming out of my regulator that also is not connected to anything. Where/what do these connect to?
Question 3: My coil has a blue wire and a black wire coming out of it. I'm assuming the black is negative, blue is positive. Do I have this hooked up correctly?
Any other tips/corrects/revisions? Any help would be greatly appreciated.