Very well done. Much better than the average!
Beautiful bike Wolds!
Can I ask what fuel tank that is and what exhaust system you have there?
Pete
View attachment 93002 View attachment 93003 View attachment 93004 View attachment 93005 View attachment 93006 View attachment 93007 View attachment 93008 View attachment 93002 member: 3530"]Wolds Please post more photos when its finished. I think the 750SS fairing looks great.
I have nothing against your idea but I think most people prefer to keep the kickstart option just in case.....best of luck though.So while I have the engine on the bench I am eliminating the kick start shaft that is sticking out of the RH side cover (see photo of my bike top of page). I am going to make a machined aluminum plug that will take the place of the shaft and seal. Is there any interest in these plugs if the prototype works out for those you that don't use the kick starter anymore? I weighed the shaft assembly less the pedal assembly and it was nearly four pounds. When I get it fabricated I'll post a few pictures. Warren
Nice!!!View attachment 94425 79 XS700 rephased
Beautiful! What forks are on it?Finally getting around to posting my project, actually finished it in Feb 2016. 75 650B. complete frame up job.
Thank you! it's a 92 GSXR750 with Cognito Stem for the XS650. Overall a lot of work if you haven't done it before. Between fitting the fork, Aligning the rotor to caliper. Then the clearance between the caliper and spokes is a little unnerving. about 6mm clearance.Beautiful! What forks are on it?
Thank you!Nice!!!