Minimal wiring to just get it started

[kelso]

I have been looking around the wiring threads and I have found what I need for a complete wiring diagram for my end setup, Pamco, PMA, cap, condenser and no battery. I would like to just get it running and timed and work out from there. In the Banshee swap thread there is mention of wiring just the ignition up to a battery to get it going but I didn't see an explanation of what that would look like. Anybody got a diagram of just what is necessary to get her running? I am not worried about the charging system right now.

 

[XSLeo]

Yes, you can hook the ignition to a battery to run the bike.
As far as wiring up the battery to the ignition you just run battery positive to a switch, from the switch to the Pamco and coil. Grounds to frame, battery negitive to frame.
Voila your wired.
Leo

 

[kelso]

Yes, you can hook the ignition to a battery to run the bike.
As far as wiring up the battery to the ignition you just run battery positive to a switch, from the switch to the Pamco and coil. Grounds to frame, battery negitive to frame.
Voila your wired.
Leo

Thanks Leo, I didn't realize it was that simple.