angus67
Welder's penetrate deeper!!
Hi guys!
so Ive got my motor buttoned up, wanted to get oil in her, and since I had it all apart, during the rebiuld, (exept the tranny) cleaned with large amounts of carb cleaner, there was ABSOLUTEY no oil any were in this motor exept the assembly lube on all the gears tranny and head.
So, Today, I put two quarts in it, and pull the plugs, and turn it over a lot O' times to circulate oil through-out. It did start to spin better, easier(kick only), so I figured good to go. being curios, I pulled the oil filter in the side case to find no oil in there.
Is that normal? the oil pump parts looked good, undamaged when I had it all aprt during rebiuld. Do these motors only pump when the motor is running?
Im soooo close to starting it, just need to mount the coil.
so Ive got my motor buttoned up, wanted to get oil in her, and since I had it all apart, during the rebiuld, (exept the tranny) cleaned with large amounts of carb cleaner, there was ABSOLUTEY no oil any were in this motor exept the assembly lube on all the gears tranny and head.
So, Today, I put two quarts in it, and pull the plugs, and turn it over a lot O' times to circulate oil through-out. It did start to spin better, easier(kick only), so I figured good to go. being curios, I pulled the oil filter in the side case to find no oil in there.
Is that normal? the oil pump parts looked good, undamaged when I had it all aprt during rebiuld. Do these motors only pump when the motor is running?
Im soooo close to starting it, just need to mount the coil.