I did a search in the archives and couldn't find anything on the very basic wiring for LED turn signals. I took my original turn signals off (they all worked) and replaced them with a set of LED's and replaced the flasher to an LED flasher (LF1-S-flat) from superbrightleds.com as recommended on this site. But now I have nothing--no flashing or no light at all from the signals. Here's my question---the original turn signals have 1 wire--red (I think is power) and another wire coming from harness to the turn signal with a rounded ferrell for the ground at where it's mounted. With the LED's--there are 2 wires coming from the turnsignal--1 red (power) & 1 black (ground?) which I didn't use because I used the original ground wire from the wiring harness as the ground on the mount. Should I have connected these two wires directly? Thanks in advance for any help