Sgilliesjr
XS650 Enthusiast
So I picked up a 1972 XS-2 basket case for less than a hand full of green backs. I have it built and am just finishing up the wiring. I am using the radio shack rectifier / NAPA regulator and I am stumped. I have poured over diagram after diagram and can't find this one little answer. Where does the Black wire on the pick up coil need to go? There was zero wiring on the bike or I would just trace the wire. The early diagrams show it grounded. I just put in the nylon screws in the pick up to unground it in order to use the NAPA regulator, so I am not sure it goes back to ground. In the later diagrams it appears to tie back into the main harness and go back to the fuse that powers the regulator a kind of loop, which doesn't seen right because you would essentially have to hots going to the pick up coil.
Any help would be greatly appreciated!!
Posted via Mobile
Any help would be greatly appreciated!!
Posted via Mobile