71 BS38 ChokePlunger06 Punch out some 0.275" (7mm) diameter plugs from 1/8" (3mm) fuel resistant neoprene. Put a tiny drop of superglue in the plung
71XS1B Carbs Overflow01 Attach a hose to the bowl's overflow barb.
71XS1B ThrottleCables Wanted to install new cables, but there's too many problems with the replacements. Wrong core diameter, solder wicked too far
71 BS38 ChokePlunger07 The new plugs MUST be trimmed to near flush with the crimped end of the plunger. Failure to do this will prevent the plunger
71 BS38 ChokePlunger06 Punch out some 0.275" (7mm) diameter plugs from 1/8" (3mm) fuel resistant neoprene. Put a tiny drop of superglue in the plung
71 BS38 ChokePlunger05 Rubber tip of starter plunger can be pried out from the crimped end.
71 BS38 ChokePlunger04 Punch out some 1/4" discs of #240 wet-or-dry sandpaper. Super glue one to the squared-off end of a 5/16" shaft. Sand the sta
71 BS38 ChokePlunger03 Another view of starter plunger seat. Viewed through outlet port.
TwoManyXS1Bs

71 BS38 ChokePlunger06 Punch out some 0.275" (7mm) diameter plugs from 1/8" (3mm) fuel resistant neoprene. Put a tiny drop of superglue in the plung

There are no comments to display.

Media information

Album
1971 XS1B BS38 carburetor rebuild
Added by
TwoManyXS1Bs
Date added
View count
1,056
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top