71XS1B #125PlateAngle The bevel edge of the #125 plate is 12.5° The ovalled long (vertical) measurements of the plate confirm that the plate would
71XS1B Butterfly Right01 My right carb's throat appears squashed, less tall than 38mm (1.496"), and wider than 38mm, by about 0.003". I was able to
71XS1B Butterfly Left02 Bored a precise 38mm (1.496") bore in a tube. Fitted the Left throttle plate to check for irregularities. The light slivers
71XS1B Butterfly Left01 My left carb's throat appears squashed, less tall than 38mm (1.496"), and wider than 38mm, by about 0.005".
71XS1B #125PlateAngle The bevel edge of the #125 plate is 12.5° The ovalled long (vertical) measurements of the plate confirm that the plate would
71XS1B #125Plate Both throttle plates measured 1.495" (37.97mm) across. This is 0.001" less than 38mm.
71XS1B Carbs Seals09 Sleeve pressed into place. Regular shaft seal fitted.
71XS1B Carbs Seals08 Brass sleeve fitted onto driver and valvestem. Press into place using thumb pressure.
TwoManyXS1Bs

71XS1B #125PlateAngle The bevel edge of the #125 plate is 12.5° The ovalled long (vertical) measurements of the plate confirm that the plate would

There are no comments to display.

Media information

Album
1971 XS1B BS38 carburetor rebuild
Added by
TwoManyXS1Bs
Date added
View count
874
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top