IMG 42- Careful not to peen downward to hard on Aluminum Clutch Housing. Strike towards the sides or edges.
IMG 39- Let gravity take it's course around the threads, lightly applied.
IMG 40- 13mm socket used on the backside.
IMG 41- 5mm Hex Bit socket inside clutch housing and 13mm socket on the back of the primary drive gear. Torque specs were just hand tighten snug, with
IMG 42- Careful not to peen downward to hard on Aluminum Clutch Housing. Strike towards the sides or edges.
IMG 43- Shot Peening applied, if you are worried about the nut falling off.
IMG 44- Additional pic of finished cush spring install.
IMG 45 Finished version of the back of the Primary Drive Gear Gear, showing the new cush springs.
YAM277

IMG 42- Careful not to peen downward to hard on Aluminum Clutch Housing. Strike towards the sides or edges.

There are no comments to display.

Media information

Album
Cush Springs / Dampening Springs Guide for Replacement
Added by
YAM277
Date added
View count
496
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top