IMG 41- 5mm Hex Bit socket inside clutch housing and 13mm socket on the back of the primary drive gear. Torque specs were just hand tighten snug, with
IMG 38- Red Permatex or Red Loc-Tite
IMG 39- Let gravity take it's course around the threads, lightly applied.
IMG 40- 13mm socket used on the backside.
IMG 41- 5mm Hex Bit socket inside clutch housing and 13mm socket on the back of the primary drive gear. Torque specs were just hand tighten snug, with
IMG 42- Careful not to peen downward to hard on Aluminum Clutch Housing. Strike towards the sides or edges.
IMG 43- Shot Peening applied, if you are worried about the nut falling off.
IMG 44- Additional pic of finished cush spring install.
YAM277

IMG 41- 5mm Hex Bit socket inside clutch housing and 13mm socket on the back of the primary drive gear. Torque specs were just hand tighten snug, with

There are no comments to display.

Media information

Album
Cush Springs / Dampening Springs Guide for Replacement
Added by
YAM277
Date added
View count
459
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top