Wondering if anyone could shed some light on an issue I have reassembling my XS crankshaft.
The spec seems to say that the width of each camshaft should be 66mm +\- 0.05mm - 0.1mm.
The overall measurement between both crank should be 186 +\- 0 - 0.3mm. This is where my problem lies.
The difference therefore would be 54mm for the centre, although try as I might I can let get them any closer than 56mm so out of tolerance.
I’ve check to ensure I hadn’t included any extra shims, and tried using about 4ton on my press but it won’t go no further. Obviously conscious to mess things up.
Have the whole crank pressed together and trued up to almost zero. But the centre clearance is out for sure as the crank won’t rotate in the casing ??
Any ideas ?
Thanks !!!
The spec seems to say that the width of each camshaft should be 66mm +\- 0.05mm - 0.1mm.
The overall measurement between both crank should be 186 +\- 0 - 0.3mm. This is where my problem lies.
The difference therefore would be 54mm for the centre, although try as I might I can let get them any closer than 56mm so out of tolerance.
I’ve check to ensure I hadn’t included any extra shims, and tried using about 4ton on my press but it won’t go no further. Obviously conscious to mess things up.
Have the whole crank pressed together and trued up to almost zero. But the centre clearance is out for sure as the crank won’t rotate in the casing ??
Any ideas ?
Thanks !!!