I've got a seized fork leg from a 650 Special 1979 or so.
I believe there is a teflon bush pressed into the top of the slider below the oil seal.
I've tried to remove the slider by normal means (penetating oil, slide hammer etc) but it's not having any of it.
So my next move is probably going to be heating the slider with the oxy-fuel at my workplace.
But just how much heat can I put in without roasting the teflon bush to destruction ?
I believe there is a teflon bush pressed into the top of the slider below the oil seal.
I've tried to remove the slider by normal means (penetating oil, slide hammer etc) but it's not having any of it.
So my next move is probably going to be heating the slider with the oxy-fuel at my workplace.
But just how much heat can I put in without roasting the teflon bush to destruction ?