Search results

79 SF with PMA, Pamco. Im running all incandescent bulbs in my signals/running, brake/running, and headlight. Im wondering what I should be getting for voltage at idle around 1200 rpm. With no lights on i get 12.4v-13v. With all lights on I get down to 11v-11.5v. Essentially with the headlight...

Running kick only,wireing overhaul, small 3 A/h batt, pamco ignition, iridium plugs, Mikuni BS38 carbs, 130 pilot jet, 2 turns out on idle mix screw. NOTE: I have NOT swapped for nylon screws on my grounded brush yet. SYMPTOMS -Idles really rough at proper idle rpm sometimes the bike quits and...

Hey there anyone know how the front bearing and spacer assembly goes together? Its not looking right to me. Is the flange supposed to slide over the spacer like in the rear? This one is a super tight fit. The diameter is significantly smaller on the flange and spacer than the bore in the hub...

Wondering if anyone has swapped stock rear m/c for a harley lockheed style rear m/c. Thanks for the advice in advance.

I regrettably picked up some rims from eBay and when they arrived looked to match up to the old ones. But after starting to build the wheel I noticed that the taper on the spoke nipples isn't sitting flush with the rim. I'm pretty sure this means I have the wrong rim but I'm looking for a...

I regrettably picked up some rims from eBay and when they arrived looked to match up to the old ones. But after starting to build the wheel I noticed that the taper on the spoke nipples isn't sitting flush with the rim. I'm pretty sure this means I have the wrong rim but I'm looking for a...

Does anyone know the length of spokes needed for these: 1.60x21x36 spoke rim to front disk hub 2.15x18x36 spoke rim to rear hub

Can anyone tell me where I can pick up a camshaft for a drum rear brake? not sure on the year of the hub or drum. thanks,

Bought an Ebay rear wheel and it didn't come with the splined brake cam. Anyone have an extra one laying around and can to ship to Canada? Or if you know what other bikes have the same compatible part that I could find on ebay. Thanks

Tried swapping my front mag on my 79 chop to a 77 spoked wheel. The rotor and calliper line up good but the speedo drive won't slide in to its holder and there's about half inch of space between the speedo drive and left fork. Anyone else know anything about this? And remedies?

Hey y'all, I am running a kick only, points ignition on my 79 650 with a solid state reg/rec. I was using a small, wet, 12V 3AH battery for about a month until it crapped out. The battery was spewing acid like nobody's business every time I rode. I'm wondering what size battery you guys are...

Does anyone know if a guy can use only one fuel inlet for two mikuni bs38s since it appears both floats are connected? I'm having a hard time splitting one line into two and keeping good flow of fuel.