Well who ever did the designing and the milling did a very nice job, bet there was a pile of chips and shavings left from that project!Not my work my friend designed and made it.
Well who ever did the designing and the milling did a very nice job, bet there was a pile of chips and shavings left from that project!Not my work my friend designed and made it.
Doing this was a bit scary.
View attachment 121115
View attachment 121116
View attachment 121117
Modified a cart I found at Delaney's the local surplus place extraordinaire.
Rolled into the garage with little problem.
We'll see if there's any issues with it being on the cart, has screw down pads so the casters aren't constantly stressed. Need to wire in it's dedicated VFD and control then finally chips!
View attachment 125201
Caught one of Joe Pieczynski's videos on cutting a radius with a fly cutter - always up for new tricks so WTH! Works pretty slick, lot easier than draggin' out the rotary table, doing all the math and what not.
Cast iron I believe. Thought maybe some one could use it, I'm sure at some point I'll come up with a use for it. Possibly a face plate if I ever get my Clausing lathe up & running.