Sorry it took so long, just got back into town, but i tested my coil and this was my readings
Lowest scale with the primary's = 2.8 ohms
Highest scale primary & center coil = 1. is open
Primary & plug wire terminal = 1. is open
Plug wire terminal & core of coil = 0.02 and i switched sides too and still got 0.02, but i think that ones is suppose to be open, infinite
Plug cap to plug cap = 0.02
took the caps off and went wire end to wire end = 0.01
Then i hooked pamco up to battery and the reading from that were obsure, it would be jumping around like a kangaroo but the rest of the pma and everything was running at 12-14 volts, so i think i need a new pamco unit and coil if im not mistaken
Replies, thanks also for the all the feedback and help too greatly appreciated