bobber bill
XS650 Addict
- Messages
- 296
- Reaction score
- 1
- Points
- 16
cleaned up and modified the diagram for 7.5A fuse. is there any reason this diagram wont work with a 72 ? thanks
breahn,
Well, there are four different coils that come with various kits, but the 17-6803 is the one that has the ends covered in plastic which block good heat conduction, so the ends need to be cleaned up.
What was the kit number and when did you buy it?
Here is another wiring diagram that shows a PAMCO and a reg/rect from a '80 to '83 model.
If you are using a stock tail light, then the color code is wrong. A stock tail light has the blue as the tail light and yellow as the brake light.
I have my red/white wire hooked in after the kill switch. This way the kill switch has to be on for the starter to work. Hate to grind on the starter till the battery is dead then realize the kill swith is off.
^^ If I'm using the stock handlebar start/stop switch, then an additional kill switch is not necessary right?
Ok Pete, last question of the day. I'm not at home so I can't check. The red/white wire coming off the solenoid should be connected to where since I don't have any relays? I should just tap it the line that goes to the coil or to the red/white wire coming of the stock handlebar switch?
Thanks again
Like this: