Hey guys just finished my xs chopper have a normal pamco unit and a pma from tcbros website. My bike just has a normal harley coil. It starts and runs but when i turn ignition on the coil draws from 12.5 volts to 3 making the pamco voltage too low so it doesnt fire. Bike has only a capicator if I hook a bike battery up it works fine. Note also my tins come back from paint tomorrow so its only run for a few seconds off of a funnel with gas. Anyone think the coil is the issue or the capicator. Im not opposed to running a battery either just want it to hold 12 something volts. Wiring has been checked and its all good, it is a very minimal harness with nothing to it except power to nessacary things. Thanks for any input.