The CX project has been on hold for several reasons, mostly excuses to disguise a lack of motivation.
1. Carbs need to be synched and tuned but that's an outdoor/open door project and it's too cold.
2. Seat cover needs to be installed, but I'm using the weather as an excuse for that as well. If I'm honest about it, I'm scared of screwing it up. If I really wanted to, I could turn the heat up in the shop.
3. New tires on on hand, but not vital and works MUCH better in warmer conditions.
4. A piece of aluminum is on-hand to form the right hand side cover but I'm the farthest thing from a tin bender. However...
I've been watching videos on forming panels on an English Wheel. Horror Fright has one that folks seem to think is at least adequate, particularly for an amateur/beginner. Thinking I'll wait until my next Insider Club 15% coupon shows up and grab one.
Any amateur tin benders here? Input/Advice?
1. Carbs need to be synched and tuned but that's an outdoor/open door project and it's too cold.
2. Seat cover needs to be installed, but I'm using the weather as an excuse for that as well. If I'm honest about it, I'm scared of screwing it up. If I really wanted to, I could turn the heat up in the shop.
3. New tires on on hand, but not vital and works MUCH better in warmer conditions.
4. A piece of aluminum is on-hand to form the right hand side cover but I'm the farthest thing from a tin bender. However...
I've been watching videos on forming panels on an English Wheel. Horror Fright has one that folks seem to think is at least adequate, particularly for an amateur/beginner. Thinking I'll wait until my next Insider Club 15% coupon shows up and grab one.
Any amateur tin benders here? Input/Advice?