blank slate
XS650 Addict
gear shift pedal shifter, not sure what it's called, but when it goes in too far it spins around and doesn't allow for shifting to occur. I tried to tighten the bolt but then the head snapped off. so i drilled out the bit that was left and put a hex bolt. i aslo put two washers to keep the shifter from sliding in. is this going to be a problem?
I'm going to go look at diagrams now to see if I'm missing a piece between shifter and the side cover.
I'm going to go look at diagrams now to see if I'm missing a piece between shifter and the side cover.
Last edited: