If you plan on retaining the factory spacers and adjusters, the extended axle plate must be centered in the original axle slot. You can achieve this b
Since the axle plates will be centered, there's enough meat for a fillet weld on either side.
Tack the plates in place. Then weld the full seam before flipping the swingarm over and welding the other side.
Ready to weld.
If you plan on retaining the factory spacers and adjusters, the extended axle plate must be centered in the original axle slot. You can achieve this b
Using the new axle plate as a guide, cut the tips off the end of the swingarm.
Grind the axle slot smooth.
Use a cutoff disk or bandsaw to cut the lines.
Ranger

If you plan on retaining the factory spacers and adjusters, the extended axle plate must be centered in the original axle slot. You can achieve this b

There are no comments to display.

Media information

Album
Swingarm extension
Added by
Ranger
Date added
View count
629
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top