Using the new axle plate as a guide, cut the tips off the end of the swingarm.
Tack the plates in place. Then weld the full seam before flipping the swingarm over and welding the other side.
Ready to weld.
If you plan on retaining the factory spacers and adjusters, the extended axle plate must be centered in the original axle slot. You can achieve this b
Using the new axle plate as a guide, cut the tips off the end of the swingarm.
Grind the axle slot smooth.
Use a cutoff disk or bandsaw to cut the lines.
On later-model swingarms, the axle slot must be extended to the rear of the swingarm. First mark two straight lines from the slot the the back of the
Ranger

Using the new axle plate as a guide, cut the tips off the end of the swingarm.

There are no comments to display.

Media information

Album
Swingarm extension
Added by
Ranger
Date added
View count
564
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top