tcyrenne
Vintage rider, newbie home builder
Hello everyone,
I am dry fitting my fuel lines today, I'm wondering if anyone sees any issues with my mock up. I'm looking for issues such as possible flow restrictions, heat concerns etc.
What my photos are trying to show is:
I have a 3 way splitter which joins the 2 petcocks and the 1 flows down to the fuel filter. The fuel lines loop down then up from the petcock to the 3 way. The 3 way seems to be either at the same level as the petcock or a bit lower.
I will be installing a stop valve, my best guess for placement is placing it in the line between the 3 way valve and fuel filter. I have seen a 3 way with a shut off valve, I had forgot to bookmark where I found it so I'm having a hard time finding it again tho.
Please let me know if I might run into fuel flow issues, of if the lines are too close to the carbs/engine
I am dry fitting my fuel lines today, I'm wondering if anyone sees any issues with my mock up. I'm looking for issues such as possible flow restrictions, heat concerns etc.
What my photos are trying to show is:
I have a 3 way splitter which joins the 2 petcocks and the 1 flows down to the fuel filter. The fuel lines loop down then up from the petcock to the 3 way. The 3 way seems to be either at the same level as the petcock or a bit lower.
I will be installing a stop valve, my best guess for placement is placing it in the line between the 3 way valve and fuel filter. I have seen a 3 way with a shut off valve, I had forgot to bookmark where I found it so I'm having a hard time finding it again tho.
Please let me know if I might run into fuel flow issues, of if the lines are too close to the carbs/engine