dan650plus
XS650 Member
- Messages
- 9
- Reaction score
- 0
- Points
- 1
Just wanted to say hi just found the site looks like the place i want to be !
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
new guy
- Thread starter dan650plus
- Start date
dan650plus
XS650 Member
- Messages
- 9
- Reaction score
- 0
- Points
- 1
thanks i did put some pix up check them out in the albums
dan650plus
XS650 Member
- Messages
- 9
- Reaction score
- 0
- Points
- 1
OK here are the details. I built this bike 5 years ago the engine was done at Bore Tech
it has a 750 kit magacycle cam mikuni vm round slides uni filters Barnett clutch and a 2 into 1 exhaust (photos show the old exhaust) front forks have progressive springs and the rear shocks are gas from Mikes XS front brake line is Spiegler stainless steel seat and tail are Hotwing Glass paint and checkers were air brushed by local TQ Auto in Amelia,Ohio dyno run shows 72 HP at wheel. Sorry to say it will be up for sail as i do not ride it much any more as i have 7 other bikes and am looking to buy something else.
it has a 750 kit magacycle cam mikuni vm round slides uni filters Barnett clutch and a 2 into 1 exhaust (photos show the old exhaust) front forks have progressive springs and the rear shocks are gas from Mikes XS front brake line is Spiegler stainless steel seat and tail are Hotwing Glass paint and checkers were air brushed by local TQ Auto in Amelia,Ohio dyno run shows 72 HP at wheel. Sorry to say it will be up for sail as i do not ride it much any more as i have 7 other bikes and am looking to buy something else.
