Vacuum type, new soft parts. Drip, drip , drip this is the normal Run position, in Prime it flows freely, Res same drip
Since it's dripping from the fuel outflow port I think it's OK? But I do not know if I put the plastic block in correctly. Too stupid to pay attention when I took it apart. I think there are two ways it will fit, one is probably wrong.
Since it's dripping from the fuel outflow port I think it's OK? But I do not know if I put the plastic block in correctly. Too stupid to pay attention when I took it apart. I think there are two ways it will fit, one is probably wrong.