ok I cant find anything on this. I replaced the clutch, laid out all parts and know correct 7 disk, bearings, alignment are all done, etc. Opposite side I replaced oil seal and bushing, while doing so removed, cleaned, lubed the worm gear. Tonight I installed new Motion Pro clutch cable.
Placed the end in housing at engine and routed up to lever. I backed off worm gear bolt to place in lever to set adjustment and ensure clutch performs correctly. Problem I have is I only have 1/4” of cable on end to connect to lever and it wont install. Is it possible I have worm gear installed incorrectly to give me more cable so I can install in lever? I can screw bolt of worm gear in and it pulls other end of cable to sheathing which is impossible to install on lever.
Placed the end in housing at engine and routed up to lever. I backed off worm gear bolt to place in lever to set adjustment and ensure clutch performs correctly. Problem I have is I only have 1/4” of cable on end to connect to lever and it wont install. Is it possible I have worm gear installed incorrectly to give me more cable so I can install in lever? I can screw bolt of worm gear in and it pulls other end of cable to sheathing which is impossible to install on lever.