in the mean time. Could we get a couple good pics of those Michelins ?
Rear size ?
Thx, -R
Surfing the web site for pics is frustrating
Rear size ?
Thx, -R
Surfing the web site for pics is frustrating
Not Michelins. Continental GOsCould we get a couple good pics of those Michelins ?
Thank you !Continental GOs
100/90 19 front
120/90 18 rear
Maybe the new Go front is even better than the Blitz front ?They feel just as good as the Blitz did.
Time will tell. I don't push them real hard so I not be the best person to judge them.Maybe the new Go front is even better than the Blitz front ?
I do not have a scope. What I am going to try is a dwell meter. Comparing how it reads running verses when it won't may tell me something.The only sure-fire test I can think of is to hang a scope on the grounding line between the coil and the Pamco, and watch the trace, like in post #49 here.
I'd say that verifies good wiring.Voltage going to PAMCO/coil stayed steady.
Only other thing I can think of is low resistance in the coil primary. Would pass more current to the Pamco... overheating it. If pri. resistance is what Pete calls for, and it don't drop when problem shows up, I'd say it's Pamco. Get it hot till it fails, disconnect one of your jumpers (quickly) and see what pri resistance. is.Anyone have any ideas?
I think the ammeter only showing 1.3 amps rules out low resistance on the primary side of the coil. I have a 7.5 amp fuse in front of the coil/PAMCO. If it was a momentary short in the primary of the coil the fuse should blow.I'd say that verifies good wiring.
Only other thing I can think of is low resistance in the coil primary. Would pass more current to the Pamco... overheating it. If pri. resistance is what Pete calls for, and it don't drop when problem shows up, I'd say it's Pamco. Get it hot till it fails, disconnect one of your jumpers (quickly) and see what pri resistance. is.
Steady.I was thinkin' more a partial short... more current, just not enough to pop the fuse. Did current remain steady at 1.3A? Or did it climb when problem started?