Hey everyone,
I recently installed my joe-wiseguy 2-1 intake manifold and vm36 carb, but I'm having some issues with the cable and throttle.
I'm using a Motion Pro 01-0249 cable and a Magura 314 throttle, but I'm having an issue where there is NO slack whatsoever (all cable adjusters are fully closed), and it's holding the throttle open as you can see in the one photo. I tried using my stock throttle instead of the Magura (same 01-0249 cable) but with the cable adjusters all the way extended there's still way too much free play (however it doesn't hold the carb slide open, which is better). Ideally I would like to not use the stock throttle, have a proper amount of free play, and have the carb slide close properly.
To anyone who is running a similar 2-1 intake setup, what throttle + cable combo are you using? Any tips or suggestions regarding my current setup?
Thanks,
padge
I recently installed my joe-wiseguy 2-1 intake manifold and vm36 carb, but I'm having some issues with the cable and throttle.
I'm using a Motion Pro 01-0249 cable and a Magura 314 throttle, but I'm having an issue where there is NO slack whatsoever (all cable adjusters are fully closed), and it's holding the throttle open as you can see in the one photo. I tried using my stock throttle instead of the Magura (same 01-0249 cable) but with the cable adjusters all the way extended there's still way too much free play (however it doesn't hold the carb slide open, which is better). Ideally I would like to not use the stock throttle, have a proper amount of free play, and have the carb slide close properly.
To anyone who is running a similar 2-1 intake setup, what throttle + cable combo are you using? Any tips or suggestions regarding my current setup?
Thanks,
padge