bobber bill
XS650 Addict
- Messages
- 296
- Reaction score
- 1
- Points
- 16
............
Last edited:
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Brembo x XS650
- Thread starter bobber bill
- Start date
Looks awesome. That is some brake sexyness right there... How thick did you end up making that spacer for the rotor? And would you be interested in machining another one? I want to use a set-up off a 91 FZR600 but I need someone to machine me up a 10 mm thick spacer. There isn't a shop anywhere close that is even remotely competent enough to tackle the job
Loffer
Master Grinder
You do fine work Bill. Thats a great setup she'll stop on a dime.
CoastsideXS650
Princeton Motor Works
Whats the thickness on that spacer you made?
I have the same rotor and caliper and want to machine one myself. If you have the specs already you can save me some time with the micrometers.
I have the same rotor and caliper and want to machine one myself. If you have the specs already you can save me some time with the micrometers.
bobber bill
XS650 Addict
- Messages
- 296
- Reaction score
- 1
- Points
- 16
theyre 14mm
Well it's related, Bill; nice work, any issues with not having the inner edge raised to maintain center on the disk?
So here's my current jump into the deep end of the pool.
the set up
The raw material
The "tool"
This is supposed to be educational isn't it?
My daddy used to be tool and die, (His lathe) I must know how to do this stuff, uh right? .........
OK how about if it doesn't kill me it'll make me stronger?
