Been battling to get these things tuned
Needle Jet=159P6
Needle=6D97
PJ=20 (tried swapped out 22.5)
MJ=180
Air jet removed
I've read that as a baseline, to set the slide heights with a 5/32" drill bit. In order for me to do that, I need to turn my throttle adjust screw out 6 turns to lower the slide. I didn't buy these carbs new, so that last guy could have screwed with them. Is it possible I have the wrong mixture screw?
Also - as a baseline, how many turns should I have the air-adjust screw at?
thanks
Needle Jet=159P6
Needle=6D97
PJ=20 (tried swapped out 22.5)
MJ=180
Air jet removed
I've read that as a baseline, to set the slide heights with a 5/32" drill bit. In order for me to do that, I need to turn my throttle adjust screw out 6 turns to lower the slide. I didn't buy these carbs new, so that last guy could have screwed with them. Is it possible I have the wrong mixture screw?
Also - as a baseline, how many turns should I have the air-adjust screw at?
thanks