jgimar
XS650 Addict
I have probably worn this subject out, but I am still looking for a miracle I guess.
5twins and a few others have been very helpful and many thanks. still having this one problem.
I have a ,77 650D, following setup:
BS38 carbs, pod filters, 1 1/2 inch open pipes reduced down with a set of torque cones and thumb screw baffle.
jetting is MJ 130, PJ 30, stock needle, stock needle jet, stock float needle, etc. all these are new as is the mix screws and choke plungers.
everything set correctly (valves, cam chain, timing, floats) close as I can tell.
not running to bad but I still have this one problem. I can't get the right side mix screw to respond.
the left one, seems to function. turn it in from 1 1/2 and it starts to cut it out. turn it back out to around 1 1/2 and it smooths out, any further and it starts to pick up rpm and popping. turn the right screw in, no response, turn it out no response.
I have cleaned every single little jet and orifice until I'm blue in the face and still can't get that right mix screw to work.
at a loss, HELP!
5twins and a few others have been very helpful and many thanks. still having this one problem.
I have a ,77 650D, following setup:
BS38 carbs, pod filters, 1 1/2 inch open pipes reduced down with a set of torque cones and thumb screw baffle.
jetting is MJ 130, PJ 30, stock needle, stock needle jet, stock float needle, etc. all these are new as is the mix screws and choke plungers.
everything set correctly (valves, cam chain, timing, floats) close as I can tell.
not running to bad but I still have this one problem. I can't get the right side mix screw to respond.
the left one, seems to function. turn it in from 1 1/2 and it starts to cut it out. turn it back out to around 1 1/2 and it smooths out, any further and it starts to pick up rpm and popping. turn the right screw in, no response, turn it out no response.
I have cleaned every single little jet and orifice until I'm blue in the face and still can't get that right mix screw to work.
at a loss, HELP!