Recent content by Bucko

hiya mate,i got some from yambits

hiya mate,from sunny{not} middlesbrough!

hiya mate,you can buy the proper tool from yambits,i think theyre about eight quid!

if you swap to the long rod do you still use the bearing also?

ive been thinking about doing something similar,are you not worried it will slip down under vibration and end up under your wheel?

have you tried yambits? if the parts are not shown on there website give them a ring,theres not much they cant get hold of!

Nice bike mate!good luck with your sale!

Hi fred,yeh the name came from my wife,your never going to ride about on that "deathtrap "are you? All the electrics run through the frame but are minimal,the ignition and light switch are mounted in a little aluminium box at the rear engine mount,and im running a cap(kicker only) so no battery...

my brit xs2

How much did they sting you for?

Any luck sorting it out mate?

Ive used smoothrite in the past,but im doing a set at the moment in 2 part,just make sure to get the cases warmed through before you paint them!

Ive got a 73 plate bike in the uk,that i believe is an xs2 also! Bit hard to tell on most parts as ive chopped it!but the front brake assembly is the same as ggggarys pic !

Have you had the motor apart?it looks like your cam bearings are off centre pushing the cover out at that side maybe?

How close to standard length are they mate?is the spindle included?and lastly are they set up for a xs650 front wheel,and very lastly :-) how much? Cheers