thatguy
XS650 Addict
Hay guys I've searched for 2 days for the answer and have not found it...
My question is were the chokes are conjoined togeather from the 2 separate bs38 carbs, there are 2 bras nipples that stick out were a rubber tube joins them. One of the bras nipples popped out and can slide in and out of the hole were it is suposed to go freely. How do I secure it? Or is there some were I can buy a new one from any where?
Also how do you sink these carbs if there are no nipples on the manifolds? ( I have already bench synced them and rebuilt them, looking to know how to sync while bike is at idle)
Just some clarification needed on the next question.
What would you recommend for a rough jetting as a starting point, if using yamama pipes and the black foam filters from pandimonium.
( I heard up a size on the pilot and 2 on the main, is this accurate or am I wrong)
My question is were the chokes are conjoined togeather from the 2 separate bs38 carbs, there are 2 bras nipples that stick out were a rubber tube joins them. One of the bras nipples popped out and can slide in and out of the hole were it is suposed to go freely. How do I secure it? Or is there some were I can buy a new one from any where?
Also how do you sink these carbs if there are no nipples on the manifolds? ( I have already bench synced them and rebuilt them, looking to know how to sync while bike is at idle)
Just some clarification needed on the next question.
What would you recommend for a rough jetting as a starting point, if using yamama pipes and the black foam filters from pandimonium.
( I heard up a size on the pilot and 2 on the main, is this accurate or am I wrong)