My XS seemed to be running better before I did the PMA and pamco. After upgrading to these parts the carbs have a bit of a sputter.
It sounded to be running OK but after I bought a timing light it was too far advanced and when I retarded it to what I thought was right the sputtering in the carb started.
It revs beautifully with the choke fully on but dies if you don't keep the rpm high, But trying to rev it up without the choke the sputtering worsens.
Also with it advanced a little to much the throttle seems to jam and stays high in the revs after I have wound it off.
I've been reading a few previous posts and hopefully this week I will pull the carbs off and give them a good clean. I think from reading they could be blocked.
I don't think anything should need adjusting??? Seeing as it ran fine before???
If you could help me narrow it down i'll be stoked.
It sounded to be running OK but after I bought a timing light it was too far advanced and when I retarded it to what I thought was right the sputtering in the carb started.
It revs beautifully with the choke fully on but dies if you don't keep the rpm high, But trying to rev it up without the choke the sputtering worsens.
Also with it advanced a little to much the throttle seems to jam and stays high in the revs after I have wound it off.
I've been reading a few previous posts and hopefully this week I will pull the carbs off and give them a good clean. I think from reading they could be blocked.
I don't think anything should need adjusting??? Seeing as it ran fine before???
If you could help me narrow it down i'll be stoked.