lonnyjones
XS650 Member
i am putting signals on my bobber, my problem is this..
1.positive wire to "flasher" then other flasher wire to signal switch
2. then positive right from switch to right turn light
3. then left positive from switch to left turn light.
everything works like this
that is simple basic...now the problem is this cool speedometer i want to use.
it is small and has a single light for "blinkers" so it has one positive and one negative wire
for the "blinker" indicator. if i connect the speedo positive wire between flasher and switch it blinks with right or left as it should...but when switch is in middle and turn signals off the blinker light on speedometer stays on solid....
how do i wire so it flashes with signals but stays off when there is no signal?
1.positive wire to "flasher" then other flasher wire to signal switch
2. then positive right from switch to right turn light
3. then left positive from switch to left turn light.
everything works like this
that is simple basic...now the problem is this cool speedometer i want to use.
it is small and has a single light for "blinkers" so it has one positive and one negative wire
for the "blinker" indicator. if i connect the speedo positive wire between flasher and switch it blinks with right or left as it should...but when switch is in middle and turn signals off the blinker light on speedometer stays on solid....
how do i wire so it flashes with signals but stays off when there is no signal?