Clerek
XS650 Enthusiast
- Messages
- 45
- Reaction score
- 0
- Points
- 6
I was reading on another thread that to rebuild the top end, hone cylinder, new pistons, new rings and gaskets was about 300 for a good deal, and upwards of 600 without. My question would be if it would be more cost efficient to just get a new set of everything from mikesxs, or get the replacement cylinder and piston kit (Part #05-0659)?
Is this kit just bolt on or do you need to do anything for this to work? I was also looking into the big bore kit too. Same question...
-Clerek
Is this kit just bolt on or do you need to do anything for this to work? I was also looking into the big bore kit too. Same question...
-Clerek