So I am in the middle of going back to points after purchasing the xs charge complete kit from tc bros. At this point I am attempting to leave the charging portion or pma installed on the bike . I have put the points back in the bike and am begging to attempt to figure this out. Also a have a couple more strikes against me. 1 I only have the timing marks on the stator that I put there when setting up the xs charge system. 2 I don't have a basic understanding of points and 3 I have a single 4 olm dual out put coil that I wired myself according to a thread I found on this site. 5 the entire wiring harness is one that I built because this is a hardtail build . With that said I'm pretty sure the wiring is correct because I had spark for a moment with the xscharge ignition. And the wiring is pretty simple. With that said I can't figure out how to make the points open and close so that I can set them at the correct gap. It's seems so simple but I'm at my wits end what in the am I missing? Why can't I figure out how to adjust points. Keep in mind while I do have power to the point so that I will be able to check with a light bulb and some alligator clips I can not start the bike so it will have to be set static first. Keep in mind I have watch a bunch of videos so I know just enough to know I dont know what I'm doing!