arborman5000
XS650 Member
- Messages
- 7
- Reaction score
- 0
- Points
- 1
Being that Im new to the rebuilding I just wanted to give a little tip that I figured out, using the back of a knife works great for smoothing any edges that may cause seeling problems. Dont really know how valid it is but I had read to use a tool for reaming pipe but thought that would cut the aluminum too deep, knife just rounds it... easier on hands anyway.
Now for question Im 90% sure I put the rocker arms back where I had taken them from yet when I mock it back they all seem to be hitting the valves to the right of center has anyone else ever experienced anything like this or did someone move mine around on me? Also is it important that they strike on center? Im sure its prefered, they basically line up at the right side.
Now for question Im 90% sure I put the rocker arms back where I had taken them from yet when I mock it back they all seem to be hitting the valves to the right of center has anyone else ever experienced anything like this or did someone move mine around on me? Also is it important that they strike on center? Im sure its prefered, they basically line up at the right side.