Venhill -3 front brakeline

[Liftedzuki]

http://www.ebay.co.uk/itm/Venhill-3...pt=UK_Motorcycle_Parts_13&hash=item20edfac1c1

http://www.ebay.co.uk/itm/Venhill-B...pt=UK_Motorcycle_Parts_13&hash=item1e92cd0b47

http://www.ebay.co.uk/itm/Venhill-b...pt=UK_Motorcycle_Parts_13&hash=item1e92e1fd08

http://www.ebay.co.uk/itm/Venhill-B...pt=UK_Motorcycle_Parts_13&hash=item20edeca4a7


This is the right fitting and hoses correct?I bought a 36" line but I need a 26" line (2" Lower forks, and drag bars)

 

[fredintoon]

Hi 'zuki,
you bought a length of hose and end fittings and you are going to put the end fittings onto the hose yourself?
Be sure the cut length is enough to still be slack at full lock and full fork extension and add a bit for when you decide you need taller bars after all.
And install the ends with extreme care.
There's going to be real high pressure in that line when the brake is on hard and that's not a good time to blow a brake hose.

 

[5twins]

I think you want a banjo with a bend in it, not just angled to the side like the one you linked to. You want something like this instead. The 20° bend is usually enough, that's about what I'm running below .....

http://www.ebay.co.uk/itm/Venhill-B...15?pt=UK_Motorcycle_Parts&hash=item1e9304bcd3

http://www.ebay.co.uk/itm/Venhill-B...pt=UK_Motorcycle_Parts_13&hash=item20edad2181

You can use a straight or slightly bent fitting at the top. Mount your MC and see what would work best for directing the line where it needs to go. The bottom fitting needs a bend to clear and provide access to the bleed nipple.

 

[Liftedzuki]

Ok so a bend for the lower is what I messed up on.

I have drag bars and need that side bend to get it away from the tank