79yam
XS650 Addict
so i took my carbs apart to ad a new gasket , i put them back on and fiddled with the a couple screws before i looked into how too tune them , oops
these are the steps i did
1. start the engine
2. turn up idle screw to high tick over
3. unplug one plug wire
4. adjust mixture screw 2 turns out
5. adjust idle screw back down to 900-1000 rpm
6. do same to other side
so i completed these steps and i have one side is back firing quite a bit.
it still seems to run poorly and will cut out after some time running
any suggestions ?
I have cut my exhaust they have no baffles and added pod filters , and have the stock jets
these are the steps i did
1. start the engine
2. turn up idle screw to high tick over
3. unplug one plug wire
4. adjust mixture screw 2 turns out
5. adjust idle screw back down to 900-1000 rpm
6. do same to other side
so i completed these steps and i have one side is back firing quite a bit.
it still seems to run poorly and will cut out after some time running
any suggestions ?
I have cut my exhaust they have no baffles and added pod filters , and have the stock jets