I am almost completed my first restore. The bike start with no problem. I have the filters off and I noticed the carb slides are not moving when I give it gas. Is that normal? It acts like it is not getting enough gas. It does idle ok. I replaced the slides and diagrams with new ones but I did have a hard time getting the diagram into the notch as I was putting on the cover. It would not lay flat like the old ones. Could that be my problem? I did spend a lot of time cleaning the carbs but I think I am going to take them off and recheck them. It almost acts like it is not getting enough gas. I pushed up on one slide and the engine sounded much better.
What type of problems would you get if the diagram is not in the proper spot?
Thanks.
Bill
What type of problems would you get if the diagram is not in the proper spot?
Thanks.
Bill