Anyone have a template?

[Sonnylynnvick75]

I'm wanting to rrid my cafe racer of those factory side panels and run flat metal along the lines of the frame, hopefully you understand what I mean. Does anyone have a build thread of how to make those or a template perhaps?

thanks
Sonny

 

[Square Circle]

Use cereal box cardboard. Cuts clean without frayed edges and gives you good lines to trace.

 

[Sonnylynnvick75]

I was looking to see if anyone already had one made up

 

[neanderthal]

itd be a lot quicker to just make your own. its really not hard at all.

 

[ogh11756]

Use cereal box cardboard. Cuts clean without frayed edges and gives you good lines to trace.

I use pizza boxes.

 

[Sonnylynnvick75]

itd be a lot quicker to just make your own. its really not hard at all.

The bends just look offset from the top rail to the bottom rail so I didn' know ho hard that would be to set up.

 

[neanderthal]

not sure what you want to do, but once you get your metal cut out you could bolt one side and then bend the other to line it up.