While preparing the heads for re-assembly i noticed the the surfaces had a small nick/scratch towards the outside as shown in the pics(close to cam bearing area). Both the head and cover have a small nick as shown in the two pics. Does anybody know if this will cause a problem - leaks, etc ? The engine was not running when i bought it so i dont know if this caused any leaks or mating problems. Given that this is on the outside i don't think it should be a problem but i hoping i could use the expertise on this forum to decide. The heads overall are in great condition and i'd hate to change them..
-
Enjoy XS650.com? Consider making a donation to help support the site.
XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Head gasket surface scratch
- Thread starter 99nomad
- Start date
I'd say no worries.
jayel
#9 Guru 74 TX650A
I agree it's to the outside and will fill with the Yamabond/Hondabond or 3bond sealer you need to use anyway
Tz250racer
XS650 Addict
- Messages
- 103
- Reaction score
- 0
- Points
- 16
JB weld works great
1974jh5
Curmudgeon.
Agree, no problem. Be sure to use the matching head and cover set, though; they are machined as a unit and will have the same numbers hand stamped. If the numbers are mixed the bearing bores may not be correct, among other things.
