That’s a terrific job, done well with simple tools. Congratulations!
Got the bmx lever in the mail and cleaned it up. Shortened the cable and added some brass fittings. It’s getting mounted on the left side frame rail under the seat. Seems to work good!
I had seen this tip before but the chuck on my little bench top drill press didn't open wide enough to give it a try. I'll give it a shot next time I have to drill out something a little smallerLooking good Hoser!
Hint to center drill in a drill press
#1 chuck your piece in the drill chuck, clamp the drill in the vice.
#2 use a center drill to start.