RedRyder
XS650 Enthusiast
Not sure, the rest of the bike is getting powder coated/painted, will stick out like its unfinishedI really like the crusty faded XS2 tank on this. Hope you are keeping it this way.
Not sure, the rest of the bike is getting powder coated/painted, will stick out like its unfinishedI really like the crusty faded XS2 tank on this. Hope you are keeping it this way.
I am hoping to get it finished by end of decemberCan’t wait to see this in situ, awesome paint scheme!
any chance on a few new bike picsI am hoping to get it finished by end of december
Frame, swing arm, engine parts still at the powder coaters. Picking up my tins from the painter next week. Then about a week or two for assembly I hope.any chance on a few new bike pics
Frame, swing arm, engine parts still at the powder coaters. Picking up my tins from the painter next week. Then about a week or two for assembly I hope.
Used whatever tubing I had that was same OD size. Cut off the rear of the frame, used metal rod and torch to make the bends. Created the piece in the center by bending tubing by hand.This looks beautiful!
Couple questions:
What size tubing/wall thickness are you using on your tubes?
Is that a Full Radius bend at the back side of the seat tube? Looks like three bends at the back... Nice work. Any advice on how to do this?
Well, of course with a help of pipe/tubing benderBy hand! Good job!