A little more on this, the new clutch bearing came today, where the old one has eight rollers this has around forty so no room for tipping, the story is tons of drag and impossible to get into neutral, new friction plates, now using two piece rod, new actuator, new cable came with bike not motion pro, i am still waiting for it, mushroom cleaned polished and relief put in centre of contact face to stop it fighting against itself, metal plates cleaned and edges beveled slightly to stop locking, preasure plate trued up it was a long way out around 20 thou, this now means that when i pull the lever i can physically turn the preasure plate whereas before no chance, the last friction plate before preasure plate goes on has had about a 2mm strip taken off it as it showed when plate was on, this will stop it dragging when plates bed in, so back together started her up while warming i oiled the clutch cable copiously as i could feel some binding, tried it out although when in gear there is a small amount of drag i can push the bike backwards while sitting on it, a massive improvement, i can now blip the throttle and flick it into neutral now, hopefully when all bedded in and motion pro cable on it will get even better, so no need for further trials at the moment.