glaswerks
XS650 Newbie (Still a newbie)
Finished removing the remainder of the unwanted brackets off of the frame.
Attempted to use the Silver and Deming bit to modify the Radian parts. Ended up in failure , found out after the fact that S&D's are not meant to open holes, only create new holes.. Will take them to a machine shop.
I also solved my rear loop issue by cutting it down about 1" in length, this allows me to mount the seat right at the top of the upper frame tubes.
Next step is to fabricate the plate for under the seat to hold the electronics and get to welding the loose ends.
Still undecided on how to install the mini tach, speedo and ignition switch.
Attempted to use the Silver and Deming bit to modify the Radian parts. Ended up in failure , found out after the fact that S&D's are not meant to open holes, only create new holes.. Will take them to a machine shop.
I also solved my rear loop issue by cutting it down about 1" in length, this allows me to mount the seat right at the top of the upper frame tubes.
Next step is to fabricate the plate for under the seat to hold the electronics and get to welding the loose ends.
Still undecided on how to install the mini tach, speedo and ignition switch.