Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS650.com?Consider making a donation to help support the site. XS650.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Soon as positive feedback gets below 99% forget them...........Got progressively worse from the last 6 months...........Has to write a book to convice the mugs to buy........Claims 2,000 sales but where is the ebay info to back up some claims
And as JD says that welding is shit and has to have porosity holes that would go right through..........I have done better alloy welding just by fusing with a gas torch,
Long, uneven, tight radius runners are a recipe for grief, as a number of guys have had to find out the hard way. If you want problems with fuel condensing out of the mix at idle and low speed operation, by all means have at it.
Not only do the welds look garbage, but they were too lazy to even round the corners on the flanges. I've seen drunk welders at my last job do better welds.